Publications

The effect of leading-edge geometry on the wake/boundary-layer interaction was studied in a low-speed single-stage HP compressor. Both a 3:1 elliptic and a circular leading edge were tested on a controlled diffusion aerofoil stator blade. Experiments were undertaken on the stator suction surface; these included hotwire boundary-layer traverses, surface hotfilm measurements, and high resolution leading-edge pressure measurements. Steady computational fluid dynamics (CFD) predictions were also performed to aid the interpretation of the results. The two leading-edge shapes gave rise to significantly different flows. For a blade with an elliptic leading edge (Blade A), the leading-edge boundary layer remained attached and laminar in the absence of wakes. The wake presence led to the formation of a thickened laminar boundary layer in which turbulent disturbances were observed to form. Measurements of the trailing-edge boundary layer indicated that the wake/leading-edge interaction for Blade

The benefits of different film cooling geometries are typically assessed in terms of their time-averaged performance. It is known that the mixing between the coolant film and the main turbine passage flow is an unsteady process. The current study investigates the forms of unsteadiness that occur in engine-representative film cooling flows and how this unsteadiness affects the mixing with the mainstream flow. Cylindrical and fan-shaped cooling holes across a range of hole blowing ratios have been studied experimentally using particle image velocimetry and high speed photography. Coherent unsteadiness is found in the shear layer between the jet and the mainstream for both cylindrical and fan-shaped cooling holes. Its occurrence and sense of rotation is found to be controlled by the velocity difference between the mainstream flow and the jet, which is largely determined by the blowing ratio.

In this paper, high and low speed tip flows are investigated for a high-pressure turbine blade. Previous experimental data are used to validate a computational fluid dynamics (CFD) code, which is then used to study the tip heat transfer in high and low speed cascades. The results show that at engine representative Mach numbers, the tip flow is predominantly transonic. Thus, compared with the low speed tip flow, the heat transfer is affected by reductions in both the heat-transfer coefficient and the recovery temperature. The high Mach numbers in the tip region (M > 1.5) lead to large local variations in recovery temperature. Significant changes in the heat-transfer coefficient are also observed. These are due to changes in the structure of the tip flow at high speed. At high speeds, the pressure side corner separation bubble reattachment occurs through supersonic acceleration, which halves the length of the bubble when the tip-gap exit Mach number is increased from 0.1 to 1.0. In addit

In this paper, the transonic flow pattern and its influence on heat transfer on a high-pressure turbine blade tip are investigated using experimental and computational methods. Spatially resolved heat transfer data are obtained at conditions representative of a single-stage high-pressure turbine blade (Mexit=1.0, Reexit=1.27×106, gap=1.5% chord) using the transient infrared thermography technique within the Oxford high speed linear cascade research facility. Computational fluid dynamics (CFD) predictions are conducted using the Rolls-Royce HYDRA/PADRAM suite. The CFD solver is able to capture most of the spatial heat flux variations and gives prediction results, which compare well with the experimental data. The results show that the majority of the blade tip experiences a supersonic flow with peak Mach number reaching 1.8. Unlike other low-speed data in the open literature, the turbine blade tip heat transfer is greatly influenced by the shock wave structure inside the tip gap. Obliqu