Hierarchical Immersed Boundary Method with Smeared Geometry
More Info
This paper presents a low-order model applying the immersed boundary method on smeared geometry. It is thus able to represent the effect of turbomachinery within a complex system. Assessment of this model on the NASA rotor 67 has been made under clean flow conditions. Good agreement has been achieved between the immersed boundary method on smeared geometry model, experiments, and a high-fidelity computational fluids dynamics model. For high-speed conditions, about within 0.5, 1, and 1% agreements are achieved on the pressure ratio, efficiency, and choking flow, respectively, between immersed the boundary method on smeared geometry model and the experiment. The capability of the model capturing the fan’s behavior under inlet distortion has also been assessed under the flow with a level of 10% distortion of the total pressure, which covers a 120 deg sector. The nonuniform work input of the fan, which is one of the key features of the fan–distortion interaction, has been captured by the i
Clocking in low-pressure turbines
More Info
The effect of stator clocking has been experimentally and computationally investigated using a low-speed, two-stage, low-pressure turbine (LPT) which was specifically designed to maximize the clocking potential by aligning the stator 1 wake segments with the stator 2 leading edge along the span. It was verified that the wake segments are aligned to within 10% of stator pitch across the span. The measured clocking effect on the work extraction is 0.12% and on efficiency is 0.08%. Although the effect of clocking is small, it is repeatable, periodic across four stator pitches and consistent between independent measurements. Furthermore, factors to consider for a reliable clocking investigation are discussed. The measurements revealed that the majority of the clocking effect on the work extraction occurs in stage 2 and it originates at stator 2 exit. This indicates that the flow is being processed differently within stator 2. There is also an effect on the stage 1 work. In each blade row, the measured clocking effect on the lost work is similar across the span. The computations with meshed cavities do not capture any clocking effects in stage 1. This indicates that an unsteady viscid phenomenon within rotor 1 is not captured by the fully turbulent calculation, e.g., unsteady transition. However, the computations do capture the measured clocking effect on the stage 2 work extraction. It is hypothesized that the clocking effect on stator 2 flow turning is dominated by a steady, inviscid process.
The Effect of Rotor Casing on Low-Pressure Steam Turbine and Diffuser Interactions
More Info
The present study aims to investigate the interaction between a last-stage steam turbine blade row and diffuser. This work is carried out using computational fluid dynamics (CFD) simulations of a generic last-stage low-pressure (LP) turbine and axial–radial exhaust diffuser attached to it. In order to determine the validity of the computational method, the CFD predictions are first compared with data obtained from an experimental test facility. A computational study is then performed for different design configurations of the diffuser and rotor casing shapes. The study focuses on typical flow features such as effects of rotor tip leakage flows and subsequent changes in the rotor–diffuser interactions. The results suggest that the rotor casing shape influences the rotor work extraction capability and yields significant improvements in the diffuser static pressure recovery.