The Effect of Non-Equilibrium Boundary Layers on Compressor Performance
More Info
The paper investigates the effect of non-equilibrium behaviour of boundary layers on the profile loss of a compressor. The investigation is undertaken using both direct numerical simulation (DNS) of a mid-height section of a compressor blade and a reduced order model, MISES. The solutions are validated using experimental measurements made in the embedded stage of a multistage low speed compressor. The paper shows that up to 35% of the suction surface boundary layer of the compressor blade exhibits non-equilibrium behaviour. The size of this region reduces as the Reynolds number is increased. The non-equilibrium behaviour was found to reduce profile loss in most cases, however, in a range of cases where transition occurs through a small separation the presence of non-equilibrium behaviour was found to increase profile loss.
Loss in Axial Compressor Bleed Systems
More Info
A new method for characterising bleed system loss is introduced, using research compressor test results as a demonstration case. A loss coefficient is defined for a control volume including only flow passing through the bleed system. The coefficient takes a measured value of 95% bleed system inlet dynamic head, and is shown to be a weak function of compressor operating point and bleed rate, varying by +/-2.2% over all tested conditions. This loss coefficient is the correct non-dimensional metric for quantifying and comparing bleed system performance.